Vibro compaction is a ground improvement technique that densifies clean, cohesionless granular soils with a downhole vibrator. It’s a technique first developed by Keller in the 1930s that we’ve used on thousands of projects since.

Vibro compaction technique image

Common uses

Reduce foundation settlement
Increase bearing capacity, allowing reduction in foundation size or width
Increasing stiffness
Increasing shear strength
Reduce permeability
Mitigate potential for liquefaction
Provide increased slope stability
Permits shallow footing construction
Very effective for sand compaction and land reclamation

Process

A vibrator hung from a crane is lowered into the ground with penetration usually helped by water jetting. The energy from the vibration reduces the inter-granular forces between the soil particles, making them denser as the vibrator is raised in lifts. Sand backfill is then poured in from ground level to compensate for any decrease in soil volumes.  More backfill is added and compacted and the vibrator is gradually removed until it has built up to ground level.

The required treatment depth is designed for each project and is typically in the range of 5 to 15 metres with a maximum depth of 40 metres.

Vibro rigs are fully instrumented with an on-board data acquisition system. Data from the system, such as amperage and lift rate, can then be recorded and displayed in real-time alongside specified target values on an in-cab monitor. This monitoring allows the operator to correct any deviations in real-time during the construction process to keep the vibro compaction within project specifications.

Specialist Contact | Derek Taylor - [email protected] - +44 (0)7769 654163

Advantages

A versatile ground-improvement method that can be adjusted to a wide variety of soil conditions and foundation requirements
Offers an economical solution for ground improvement
Relatively quick execution so subsequent structural works can follow very quickly
Soil improvement enables standard shallow footings which can lead to savings
Environmentally-friendly as uses natural and in situ materials
Extremely quiet with low vibration
Only a small quantity of soil has to be removed during the process so avoids the cost of spoil removal associated with continous flight auger and bored piling systems

Quality assurance

The vibro equipment we use is designed and manufactured by our in-house equipment manufacturer exclusively for use by Keller companies.

In-house quality production management software enables us to capture and analyse data in real time and valid the performance of the ground improvement being carried out.

A variety of production parameters are generally logged during execution including depth, current, pull down force, uplift/pull down sequence, time and date and element number.

Field trials can also be used to verify column production parameters, along with static load tests (single or group), column material compressive strength tests, and column diameter verification.